Home WTI User's Guides
cover
Warnings and Cautions
1. Introduction
2. Unit Description
2.2. Back Panel
3. Getting Started
3.1. Communication Parameters
3.2. Apply Power to the APS-16
3.3. Connecting your PC to the APS-16
3.4. Communicating with the APS-16 Unit
4. Hardware Installation
4.1. Configure Setup Switches
4.1.1. Default Baud Rate
4.2. Initialize Unit to Default Settings
4.3. Connecting Devices to the APS-16
5. Configuration
5.1. Access to the APS-16 Command Mode
5.2. Defining and Reading the Site I.D.
5.3. Port Configuration
5.3.1. Configuration Conventions
5.3.2. Port Modes
5.3.3. Command Availability
5.3.4. Port Configuration Menu
6. Operation
6.1. Any-to-Any Mode
6.1.1. Port Connection and Disconnection
6.1.1.1. Using ASCII Commands to Connect Ports
6.1.1.2. Disconnecting Ports
6.1.2. Defining Hunt Groups
6.2. Passive Mode
6.3. Buffer Mode
6.3.1. Reading Data from Buffer Mode Ports
6.3.2. Port Buffers
6.4. Modem Mode
7. Saving Configuration Parameters
7.1. Sending Parameters to a File
7.2. Restoring Saved Parameters
8. Command Reference Guide
8.1. Command Conventions
8.2. Command Response
8.3. Command Summary
8.4. Command Set
A. RS-232 Port Interface
B. Specifications
C. Customer Service
Index
APS-16

2. Unit Description

 

C CLEAR: Restarts the APS-16 operating program without changing user-selected parameter settings or breaking port connections. 
@ ON: Lights when AC Power is applied. 
@ SET: Used to Initialize the APS-16 to defaults specified by the SetUp Switches. To initialize, press and hold both the SET and CLEAR buttons, release only the CLEAR button, and then release the SET button. 
Note: 
During initialization, all command-selected parameters will be cleared, and the APS-16 will revert to the default parameters specified by the SetUp Switches. 
  RDY: Flashes to indicate unit is operational. 
  ACTIVITY Leds (1 -16): Light to indicate that corresponding port is receiving data.