Home WTI User's Guides
cover
Warnings and Cautions
1. Introduction
2. Unit Description
2.2. Back Panel
3. Getting Started
3.1. Communication Parameters
3.2. Apply Power to the APS-16
3.3. Connecting your PC to the APS-16
3.4. Communicating with the APS-16 Unit
4. Hardware Installation
4.1. Configure Setup Switches
4.1.1. Default Baud Rate
4.2. Initialize Unit to Default Settings
4.3. Connecting Devices to the APS-16
5. Configuration
5.1. Access to the APS-16 Command Mode
5.2. Defining and Reading the Site I.D.
5.3. Port Configuration
5.3.1. Configuration Conventions
5.3.2. Port Modes
5.3.3. Command Availability
5.3.4. Port Configuration Menu
6. Operation
6.1. Any-to-Any Mode
6.1.1. Port Connection and Disconnection
6.1.1.1. Using ASCII Commands to Connect Ports
6.1.1.2. Disconnecting Ports
6.1.2. Defining Hunt Groups
6.2. Passive Mode
6.3. Buffer Mode
6.3.1. Reading Data from Buffer Mode Ports
6.3.2. Port Buffers
6.4. Modem Mode
7. Saving Configuration Parameters
7.1. Sending Parameters to a File
7.2. Restoring Saved Parameters
8. Command Reference Guide
8.1. Command Conventions
8.2. Command Response
8.3. Command Summary
8.4. Command Set
A. RS-232 Port Interface
B. Specifications
C. Customer Service
Index
APS-16

4.1. Configure Setup Switches

 

When the APS-16 is shipped from the factory, the Setup Switches are configured for 9600 baud, 8 Bits-No Parity, RTS/CTS handshaking, verbose command response, and no echo (all switches ON). These switch settings are compatible with most applications. If the default settings are not compatible with your application, change the switch settings as described in the following subsections.

Setup Switches should be configured to match the parameters used by the device attached to Port 1. This allows access to command functions if the unit is initialized to default parameters.

Note:

•                      Please refer to the label on the bottom of the APS-16 in order to determine On/Off positions.

•                      Communication parameters (baud rate, parity, etc.) can be selected for each port using the /P command as described in Section 5.3. The /P command can select different parameters for each APS-16 port.

•                      When the APS-16 is initialized, parameters will return to the settings specified by the Set-Up Switches.