Home WTI User's Guides
cover
Warnings and Cautions
1. Introduction
2. Unit Description
2.2. Back Panel
3. Getting Started
3.1. Communication Parameters
3.2. Apply Power to the APS-16
3.3. Connecting your PC to the APS-16
3.4. Communicating with the APS-16 Unit
4. Hardware Installation
4.1. Configure Setup Switches
4.1.1. Default Baud Rate
4.2. Initialize Unit to Default Settings
4.3. Connecting Devices to the APS-16
5. Configuration
5.1. Access to the APS-16 Command Mode
5.2. Defining and Reading the Site I.D.
5.3. Port Configuration
5.3.1. Configuration Conventions
5.3.2. Port Modes
5.3.3. Command Availability
5.3.4. Port Configuration Menu
6. Operation
6.1. Any-to-Any Mode
6.1.1. Port Connection and Disconnection
6.1.1.1. Using ASCII Commands to Connect Ports
6.1.1.2. Disconnecting Ports
6.1.2. Defining Hunt Groups
6.2. Passive Mode
6.3. Buffer Mode
6.3.1. Reading Data from Buffer Mode Ports
6.3.2. Port Buffers
6.4. Modem Mode
7. Saving Configuration Parameters
7.1. Sending Parameters to a File
7.2. Restoring Saved Parameters
8. Command Reference Guide
8.1. Command Conventions
8.2. Command Response
8.3. Command Summary
8.4. Command Set
A. RS-232 Port Interface
B. Specifications
C. Customer Service
Index
APS-16

4.2. Initialize Unit to Default Settings

 

If Setup Switches are changed, new parameters will not take effect until the unit is initialized. After initialization, command selected parameters will be lost.

Caution: After initialization, the unit will revert to the parameters specified by the SetUp Switches. Any command-selected parameters will be lost.

1                     Simultaneously press the SET and CLEAR buttons, located on the face of the APS-16 unit.

2                     Release the CLEAR button, wait one second, and then release the SET button.