Home WTI User's Guides
cover
Warnings and Cautions
1. Introduction
2. Unit Description
2.2. Back Panel
3. Getting Started
3.1. Communication Parameters
3.2. Apply Power to the APS-16
3.3. Connecting your PC to the APS-16
3.4. Communicating with the APS-16 Unit
4. Hardware Installation
4.1. Configure Setup Switches
4.1.1. Default Baud Rate
4.2. Initialize Unit to Default Settings
4.3. Connecting Devices to the APS-16
5. Configuration
5.1. Access to the APS-16 Command Mode
5.2. Defining and Reading the Site I.D.
5.3. Port Configuration
5.3.1. Configuration Conventions
5.3.2. Port Modes
5.3.3. Command Availability
5.3.4. Port Configuration Menu
6. Operation
6.1. Any-to-Any Mode
6.1.1. Port Connection and Disconnection
6.1.1.1. Using ASCII Commands to Connect Ports
6.1.1.2. Disconnecting Ports
6.1.2. Defining Hunt Groups
6.2. Passive Mode
6.3. Buffer Mode
6.3.1. Reading Data from Buffer Mode Ports
6.3.2. Port Buffers
6.4. Modem Mode
7. Saving Configuration Parameters
7.1. Sending Parameters to a File
7.2. Restoring Saved Parameters
8. Command Reference Guide
8.1. Command Conventions
8.2. Command Response
8.3. Command Summary
8.4. Command Set
A. RS-232 Port Interface
B. Specifications
C. Customer Service
Index
APS-16

5.2. Defining and Reading the Site I.D.

 

When your application involves communication with several APS-16 units, the Site I.D. can indicate the location or name of each unit. If you have already defined the Site I.D. in Section 3, and have not re-initialized the APS-16, skip this section.

Note:

•                      The Site I.D., cannot include non-printable ASCII characters, such as nulls or Line Feeds.

•                      The Site I.D. will be cleared when the APS-16 is initialized to default settings.

 

1                     Access the Command Mode.

2                     Type /F [Enter]. The APS-16 will display the Site I.D. Prompt. Key in the desired text (up to 32 characters) and press [Enter].

3                     To display the Site I.D., type /J [Enter]