Home WTI User's Guides
cover
Warnings and Cautions
1. Introduction
2. Unit Description
2.2. Back Panel
3. Getting Started
3.1. Communication Parameters
3.2. Apply Power to the APS-16
3.3. Connecting your PC to the APS-16
3.4. Communicating with the APS-16 Unit
4. Hardware Installation
4.1. Configure Setup Switches
4.1.1. Default Baud Rate
4.2. Initialize Unit to Default Settings
4.3. Connecting Devices to the APS-16
5. Configuration
5.1. Access to the APS-16 Command Mode
5.2. Defining and Reading the Site I.D.
5.3. Port Configuration
5.3.1. Configuration Conventions
5.3.2. Port Modes
5.3.3. Command Availability
5.3.4. Port Configuration Menu
6. Operation
6.1. Any-to-Any Mode
6.1.1. Port Connection and Disconnection
6.1.1.1. Using ASCII Commands to Connect Ports
6.1.1.2. Disconnecting Ports
6.1.2. Defining Hunt Groups
6.2. Passive Mode
6.3. Buffer Mode
6.3.1. Reading Data from Buffer Mode Ports
6.3.2. Port Buffers
6.4. Modem Mode
7. Saving Configuration Parameters
7.1. Sending Parameters to a File
7.2. Restoring Saved Parameters
8. Command Reference Guide
8.1. Command Conventions
8.2. Command Response
8.3. Command Summary
8.4. Command Set
A. RS-232 Port Interface
B. Specifications
C. Customer Service
Index
APS-16

5.3.3. Command Availability

 

The "Commands" field in the Port Configuration menu allows the user to specify which commands will be available to each Any­to-Any Mode or Modem Mode port. The user can either select "All" commands or only "Basic" commands. The "All" option is normally selected for administrator ports; "Basic" is normally selected for user ports, and allows limited access to commands. Section 8.3 summarizes "All" and "Basic" commands.

Note that the Status Screen (Command /S) will include a plus sign (+) next to the port number when a port has been granted access to All commands.

In the default state, Ports 1 and 2 are the only ports with access to "All" commands. When ports are configured, at least one port should be granted access to "All" commands.