Home WTI User's Guides
cover
Warnings and Cautions
1. Introduction
2. Unit Description
2.2. Back Panel
3. Getting Started
3.1. Communication Parameters
3.2. Apply Power to the APS-16
3.3. Connecting your PC to the APS-16
3.4. Communicating with the APS-16 Unit
4. Hardware Installation
4.1. Configure Setup Switches
4.1.1. Default Baud Rate
4.2. Initialize Unit to Default Settings
4.3. Connecting Devices to the APS-16
5. Configuration
5.1. Access to the APS-16 Command Mode
5.2. Defining and Reading the Site I.D.
5.3. Port Configuration
5.3.1. Configuration Conventions
5.3.2. Port Modes
5.3.3. Command Availability
5.3.4. Port Configuration Menu
6. Operation
6.1. Any-to-Any Mode
6.1.1. Port Connection and Disconnection
6.1.1.1. Using ASCII Commands to Connect Ports
6.1.1.2. Disconnecting Ports
6.1.2. Defining Hunt Groups
6.2. Passive Mode
6.3. Buffer Mode
6.3.1. Reading Data from Buffer Mode Ports
6.3.2. Port Buffers
6.4. Modem Mode
7. Saving Configuration Parameters
7.1. Sending Parameters to a File
7.2. Restoring Saved Parameters
8. Command Reference Guide
8.1. Command Conventions
8.2. Command Response
8.3. Command Summary
8.4. Command Set
A. RS-232 Port Interface
B. Specifications
C. Customer Service
Index
APS-16

7.1. Sending Parameters to a File

 

1                     Start Procomm and access the APS-16 Command Mode.

2                     Use the /P command to disable the APS-16's echo feature as described in Section 5. When the Port Configuration menu is displayed, option 12 enables/disables the echo feature.

3                     Press the [Page Down] key.

4                     ProComm's Download Menu will appear. Select (A) ASCII. ProComm will display a prompt which reads "ASCII DOWNLOAD -Please enter file name".

5                     Type in a name for the file that will contain the saved APS­16 parameters using the full path and drive designation. For example, "C:\APS.PAR".

 

6. At the ProComm screen, type /U and press [Enter]. The APS-16 will send a series of command lines to the file specified in Step 5. Each line describes parameters for an individual Port.

a) The /U command must be invoked before ProComm's download timeout is reached. The download timeout can be redefined using ProComm's set-up menu.

b) ProComm will emit a Beep when the download timeout period has elapsed.

7. When the APS-16 has finished sending parameters, press [Esc] to terminate ProComm's Download mode.