Home WTI User's Guides
cover
Warnings and Cautions
1. Introduction
2. Unit Description
2.2. Back Panel
3. Getting Started
3.1. Communication Parameters
3.2. Apply Power to the APS-16
3.3. Connecting your PC to the APS-16
3.4. Communicating with the APS-16 Unit
4. Hardware Installation
4.1. Configure Setup Switches
4.1.1. Default Baud Rate
4.2. Initialize Unit to Default Settings
4.3. Connecting Devices to the APS-16
5. Configuration
5.1. Access to the APS-16 Command Mode
5.2. Defining and Reading the Site I.D.
5.3. Port Configuration
5.3.1. Configuration Conventions
5.3.2. Port Modes
5.3.3. Command Availability
5.3.4. Port Configuration Menu
6. Operation
6.1. Any-to-Any Mode
6.1.1. Port Connection and Disconnection
6.1.1.1. Using ASCII Commands to Connect Ports
6.1.1.2. Disconnecting Ports
6.1.2. Defining Hunt Groups
6.2. Passive Mode
6.3. Buffer Mode
6.3.1. Reading Data from Buffer Mode Ports
6.3.2. Port Buffers
6.4. Modem Mode
7. Saving Configuration Parameters
7.1. Sending Parameters to a File
7.2. Restoring Saved Parameters
8. Command Reference Guide
8.1. Command Conventions
8.2. Command Response
8.3. Command Summary
8.4. Command Set
A. RS-232 Port Interface
B. Specifications
C. Customer Service
Index
APS-16

7.2. Restoring Saved Parameters

 

This section describes the procedure for using ProComm to send stored parameters to the APS-16.

1                     Start ProComm and access the APS-16 Command Mode. Press the [Page Up] key to activate ProComm's Upload menu.

2                     Select (A) ASCII. The system will display a prompt which reads "ASCII UPLOAD -Please enter the file name".

3                     Key in the name of the ASCII text file with the stored parameters using the full path and drive designation and press [Enter]. For example, C:\APS.PAR [Enter].

4                     ProComm will send the ASCII text file to the APS-16 and saved parameters will be restored. When ProComm has finished sending parameters, press [Esc] to terminate ProComm's Upload mode.

5                     Type /S and press [Enter], the APS-16's Status Screen will be displayed. Check the Status Screen to make certain the APS-16 has been configured with the saved parameters.