Home WTI User's Guides
cover
Warnings and Cautions
1. Introduction
2. Unit Description
2.1. Front Panel
2.2. Back Panel
3. Getting Started
3.1. Communication Parameters
3.2. Apply Power to the APS
3.3. System SetUp Ports
3.4. Connecting your PC to the APS
3.5. Communicating with the APS Unit
4. Hardware Installation
4.1. Connecting Power to the APS Unit
4.1.1. AC Powered Units
4.1.2. DC Powered Units
4.2. Configure SetUp Switches
4.2.1. Default Baud Rate
4.2.2. Default Handshake
4.2.3. Default Response Message Format
4.2.4. Default Command Echo
4.3. Initialize Unit to Default Settings
4.4. Connecting Devices to the APS
4.5. Application Example
5. Configuration
5.1. Access to the APS Command Mode
5.2. System SetUp Ports
5.3. Password Functions
5.3.1. The Supervisor Password
5.3.2. The Port Passwords
5.4. Defining the Site ID and Supervisor Password
5.5. Port Configuration
5.5.1. Configuration Conventions
5.5.2. Port Modes
5.5.3. RS232 Port Configuration Menus
5.6. Copying Parameters to All Ports
5.7. Save User Selected Parameters
6. The Status Screens
6.1. The Port Status Screen
6.2. The Port Diagnostics Screen
6.3. The Port Parameters Screens
7. Operation
7.1. Any-to-Any Mode
7.1.1. Port Connection and Disconnection
7.1.1.1. Connecting Ports
7.1.1.2. Disconnecting Ports
7.1.2. Defining Hunt Groups
7.2. Passive Mode
7.3. Buffer Mode
7.3.1. Reading Data from Buffer Mode Ports
7.3.2. Port Buffers
7.4. Modem Mode
8. Saving and Restoring Configuration Parameters
8.1. Sending Parameters to a File
8.2. Restoring Saved Parameters
9. Command Reference Guide
9.1. Command Conventions
9.2. Command Response
9.3. Command Summary
9.4. Command Set
A. RS232 Port Interface
B. Specifications
C. Customer Service
Index