Home WTI User's Guides
cover
1. Introduction
2. Unit Description
2.1. CPM-400 Table Top Unit
2.1.1. CPM-400- Top Panel
2.1.2. CPM-400 Back Panel
2.2. CPM-400R Rack Mount Unit
2.2.1. CPM-400R Front Panel
2.2.2. CPM-400R Back Panel
3. Getting Started
3.1. Communication Parameters
3.2. Connecting your PC to the CPM
3.3. Apply Power
3.4. Communicating with the CPM
4. Hardware Installation
4.1. Configure Setup Switches
4.1.1. Default Baud Rate
4.1.2. Default Handshake Format
4.1.3. Default Response Message Format
4.1.4. Default Command Echo
4.2. Initialize Unit to Default Settings
4.3. Connecting a Modem
4.4. Connecting Devices to the CPM
5. Configuration
5.1. Access to Command Mode
5.2. Defining and Reading the Site I.D.
5.3. Port Configuration
5.3.1. Configuration Conventions
5.3.2. Port Modes
5.3.2.1. The Any-To-Any Mode
5.3.2.2. The Modem Mode
5.3.3. Command Availability
5.3.4. Port Configuration Commands
6. Operation
6.1. Port Connection and Disconnection
6.1.1. Using ASCII Commands to Connect Ports
6.1.2. Disconnecting Ports
6.2. Defining Hunt Groups
7. Saving Configuration Parameters
7.1. Sending Parameters to a File
7.2. Restoring Saved Parameters
8. Command Reference Guide
8.1. Command Conventions
8.2. Command Response
8.3. Command Availability
8.4. Command Set
A. Description of System Interfaces
A.1. RS-232 Ports
A.1.2. Circuitry at Ports 3 and 4
A.2. RS-232 Ports
A.3. Snap Adapters
A.4. RJ11 Cables
B. Specifications
C. FCC Notice
D. Customer Service
Index