Home WTI User's Guides
cover
1. Introduction
2. Unit Description
2.1. Front Panel
2.2. Back Panel
3. Getting Started
3.1. Communication Parameters
3.2. Connecting your PC to the CPM
3.3. Apply Power to the CPM
3.4. Communicating with the CPM Unit
4. Hardware Installation
4.1. Configure Setup Switches
4.1.1. Default Baud Rate
4.1.2. Default
4.1.3. Default Response Message Format
4.1.4. Default Command Echo
4.2. Connecting a Modem to the CPM
4.3. Initialize the Unit to Default Settings
4.4. Connecting Devices to the CPM
5. Configuration
5.1. Access to the CPM Command Mode
5.2. Defining and Reading the Site I.D.
5.3. Port Configuration
5.3.1. Configuration Conventions
5.3.2. Port Modes
5.3.2.1. The Any-To-Any Mode
5.3.2.2. The Modem Mode
5.3.3. Command Availability
5.3.4. Port Configuration Commands
6. Operation
6.1. Port Connection and Disconnection
6.1.1. Using ASCII Commands to Connect Ports
6.1.2. Disconnecting Ports
6.2. Defining Hunt Groups
6.3. Port Buffers
7. Saving Configuration Parameters
7.1. Sending Parameters to a File
7.2. Restoring Saved Parameters
8. Command Reference Guide
8.1. Command Conventions
8.2. Command Response
8.3. Command Summary
8.4. Command Set
A. Description of System Interfaces
A.1. RS-232 Ports
A.1.1. Circuitry at Ports 1 and 2
A.1.2. Circuitry at Ports 3 and Above
A.2. Snap Adapters
A.3. Cables
B. Specifications
C. FCC Notice
D. Customer Service