Home WTI User's Guides
cover
1. Introduction
2. Unit Description
2.1. Front Panel
2.2. Back Panel
3. Getting Started
3.1. Communication Parameters
3.2. Connecting your PC to the MDS
3.3. Apply Power to the MDS
3.4. Communicating with the MDS Unit
4. Hardware Installation
4.1. Configure Setup Switches
4.1.1. Default Baud Rate
4.1.2. Default Handshake
4.1.3. Default Response Message Format
4.1.4. Default Command Echo
4.2. Initialize the Unit to Default Settings
4.3. Connecting Devices to the MDS
5. Configuration
5.1. Access to the MDS Command Mode
5.2. Defining and Reading the Site I.D.
5.3. Port Configuration
5.3.1. Configuration Conventions
5.3.2. Port Modes
5.3.3. Command Availability
5.3.4. Port Configuration Command
6. Operation
6.1. Any-to-Any Mode
6.1.1. Port Connection and Disconnection
6.1.1.1. Using ASCII Commands to Connect Ports
6.1.1.2. Disconnecting Ports
6.1.2. Defining Hunt Groups
6.1.3. Port Buffers and Any-to-Any Mode Ports
6.2. Buffer Mode
6.2.1. Reading Data from Buffer Mode Ports
6.3. Mux Mode
6.3.1. Bi-directional Communication in Mux Mode
7. Saving Configuration Parameters
7.1. Sending Parameters to a File
7.2. Restoring Saved Parameters
8. Command Reference Guide
8.1. Command Conventions
8.2. Command Response
8.3. Command Summary
8.4. Command Set
A. Description of System Interfaces
A.1. RS-232 Ports A.2. Snap Adapters
A.3. Cables
B. Specifications
C. FCC Notice
D. Customer Service