Home WTI User's Guides
cover
1. Introduction
2. Unit Description
2.1. Front Panel
2.2. Back Panel
3. System Overview
3.1. Communication Parameters
3.2. Apply Power to the RSM-800
3.3. Connecting your PC to the RSM-800
3.4. Communicating with the RSM-800
4. Hardware Installation
4.1. Configure Setup Switches
4.1.1. Default Baud Rate
4.1.2. Default
4.1.3. Default Response Message Format
4.1.4. Default Command Echo
4.2. Initialize the Unit to Default Settings
4.3. Connecting the Network Cable
4.4. Connecting Devices to the RSM-800
5. Configuration
5.1. Communication During Initial Configuration
5.2. Defining and Reading the Site I.D.
5.3. Port Configuration
5.3.1. Configuration Conventions
5.3.2. Port Modes
5.3.2.1. The Net Mode
5.3.2.2. The Any-to-Any Mode
5.3.2.3. The Buffer Mode
5.3.2.4. The Modem Mode
5.3.3. Command Availability
5.3.4. Selecting Parameters for TCP-IP Networks
5.3.5. Port Configuration Commands
5.4. Implementing IP Security
5.4.1. IP Security Filter Examples
6. Operation
6.1. Access to the RSM-800 Command Mode
6.1.1. Access via Local PC
6.1.2. Access via Modem
6.1.3. Access via TCP-IP Network
6.1.4. Access via Netware 3.x-4.x Network
6.2. Port Connection and Disconnection
6.2.1. Using ASCII Commands to Connect Ports
6.2.2. Disconnecting Ports
6.3. Defining Hunt Groups
6.4. The Buffer Mode
6.5. Pass-through to Network
7. Saving Configuration Parameters
7.1. Sending Parameters to a File
8. Command Reference Guide
8.1. Command Conventions
8.2. Command Response
8.3. Command Summary
8.4. Command Set
A. Description of System Interface
A.1. Ports 2 through 8
B. Specifications
C. FCC Notice
D. Customer Service
Index