Home WTI User's Guides
cover
1. Introduction
2. Unit Description
2.1. Front Panel
2.2. Back Panel PSU-82C
2.3. Back Panel PSU-82SP
3. Installation
3.1. Configure SetUp Switches
3.1.1. PSU-82C SetUp Switches
3.1.1.1. PSU-82C Baud Rate Bank 1 DIP 1
3.1.1.2. PSU-82C Parity Bank 1 DIPs2-3
3.1.1.3. PSU-82C Handshake Bank 1 DIP 4
3.1.1.4. PSU-82C Default Printer Bank 1 DIP 5
3.1.1.5. PSU-82C Automatic TOF Bank 1 DIP 6
3.1.1.6. PSU-82C Timeout Value Bank 1 DIPs7-8
3.1.1.7. PSU-82C IBM Auto-Feed Bank 2 DIP 1
3.1.1.8. Printer Output Mode Bank 2 DIPs3-4
3.1.2. PSU-82SP SetUp Switches
3.1.2.1. PSU-82SP Input Baud Rate Sw1
3.1.2.2. PSU-82SP Output Baud Rate Sw2
3.1.2.3. PSU-82SP Parity Sw3
3.1.2.4. PSU-82SP Handshake Format Sw4
3.1.2.5. PSU-82SP Default Printer Sw5
3.1.2.6. PSU-82SP Automatic TOF Sw6
3.1.2.7. PSU-82SP Timeout Value Sw7 Sw8
3.1.2. PSU-82SP SetUp Switches
3.1.2.1. PSU-82SP Input Baud Rate Sw1
3.1.2.2. PSU-82SP Output Baud Rate Sw2
3.1.2.3. PSU-82SP Parity Sw3
3.1.2.4. PSU-82SP Handshake Format Sw4
3.1.2.5. PSU-82SP Default Printer Sw5
3.1.2.6. PSU-82SP Automatic TOF Sw6
3.1.2.7. PSU-82SP Timeout Value Sw7 Sw8
3.1.2.8. PSU-82SP Printer Output Mode Sw9 Sw10
3.2. Initialize Unit
3.3. Connect Power Cable
3.4. Initial Check
3.5. Connect Printers
3.6. Connect Computers
3.7. Final Check
4. Operation
4.1. Additional Front Panel Functions
4.1.1. Send Test Message
4.1.2. RAM Test - Initialize Unit
4.2. Operation Summary
A. Interface Descriptions
A.1. Serial Ports
A.1..1. Serial Input Cabling Suggestions
A.1..2. Serial Output Cabling Suggestions
A.2. 36-Pin Parallel Interface -PSU-82SP
A.3. 25-Pin Parallel Interface
B. Troubleshooting
C. Application Example
D. Linking Several PSUs
E. Options and Accessories
F. Specifications
G. Customer Service
H. FCC Statement
Trademark and Copyright Information
82C - PSU-82SP

3.1. Configure SetUp Switches

 

The SetUp Switches select default values for baud rate, parity, handshake format and other parameters. Note that the SetUp Switches for the PSU-82C and PSU-82SP differ slightly.

Review the default settings listed in the section for the your specific unit. If these parameters are not compatible with your application, refer to the sections that follow and configure SetUp Switches accordingly.