Home WTI User's Guides
cover
1. Introduction
2. Unit Description
2.2. Back Panel
3. Installation
3.1. PBX Port Connection
3.2. Computer Port Connection
3.3. Speed Select Switches
3.3.1. Computer Port Baud Rate
3.3.2. PBX Port Baud Rate
3.3.3. Output Parity
3.3.4. Single Line Release Function
3.3.5. Modem Mode
4. Operation
4.1. Clear Memory
4.2. Test Memory
4.3. Command Set
4.4. Data Release
4.4.1. XON-XOFF Flow Control
4.4.2. CTS-RTS Flow Control
4.4.3. DTR Flow Control
4.5. Auto-Erase Function
4.6. Output Test Function
4.7. The Modem Mode
5. Interface Descriptions
5.1. Computer Port
5.1.1. Connecting a Modem
5.2. PBX Port
6. Specifications
7. Customer Service
PollCat-ILB

3. Installation

 

This section describes the procedures for configuring the Setup Switches, and connecting the ILB to your PBX system and PC. Briefly, the installation procedure consists of the following steps:

1                     Connect your PBX system's SMDR Port to the ILB's PBX Port.

2                     Connect your PC, polling device, or external modem to the ILB's Computer Port.

3                     Set the Speed Select Switches for the desired baud rates and other operating parameters as described in Section 3.3.

4                     Connect the power cable and power up the ILB. Perform the Memory Test as described in Section 4.2 to test and clear the ILB's battery backed memory.