Home WTI User's Guides
cover
1. Introduction
2. Unit Description
2.2. Back Panel
3. Installation
3.1. PBX Port Connection
3.2. Computer Port Connection
3.3. Speed Select Switches
3.3.1. Computer Port Baud Rate
3.3.2. PBX Port Baud Rate
3.3.3. Output Parity
3.3.4. Single Line Release Function
3.3.5. Modem Mode
4. Operation
4.1. Clear Memory
4.2. Test Memory
4.3. Command Set
4.4. Data Release
4.4.1. XON-XOFF Flow Control
4.4.2. CTS-RTS Flow Control
4.4.3. DTR Flow Control
4.5. Auto-Erase Function
4.6. Output Test Function
4.7. The Modem Mode
5. Interface Descriptions
5.1. Computer Port
5.1.1. Connecting a Modem
5.2. PBX Port
6. Specifications
7. Customer Service
PollCat-ILB

4.6. Output Test Function

 

The Output Test Function is used to check for proper connection between the ILB and polling device. When the Output Test is initiated, the ILB will release a single test string. Note that this test can be performed even when ILB memory is empty.

To initiate the Output Test Function, type ^T ([Ctrl] + [T]) and then press [Enter]. Note that the DTR line must be active, and XON/XOFF characters can be used for flow control while the Output Test String is being sent.